If you have selected a range of configurations (different numbers, sizes, and speeds of cars) to analyse in Elevator Data, you can choose to display only the results that meet specified criteria. The options available depend on the analysis type.
If the analysis type is Up Peak, results can be excluded if the configuration achieves less than a specified five-minute handling capacity.
If the analysis type is Enhanced Up Peak, General Analysis or Double Deck General Analysis, results can be excluded if the interval, capacity factor by mass, or by area is higher than specified.
If the analysis type is Simulation, you can choose to view results for any individual run or an average of all runs. You can also filter by passengers arriving in a specific time frame. Based on this selection, you may reject results where the Average Waiting Time, Average Transit Time, or Average Time to Destination exceeds a specified threshold. The Maximum Queue input allows you to exclude results where the total queue across all floors exceeds a defined percentage of the building population. This variable is monitored during the simulation run and can help abort unsuitable solutions early, saving time.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article