Drive

This input is only applicable if the analysis type is Simulation. The Energy Model must be turned on in Analysis Data.

Select the drive type for analysis. The available options are: Hydraulic, MRL (Machine Room Less), Modern Drive Regenerative, Modern Drive Non-Regenerative, and DC with Motor Generator Set. According to the drive selection, Elevate makes assumptions about the energy consumption of the elevators at different loads in the up and down direction. It then calculates the energy used for each trip and sums these results.

The assumptions made about the energy consumption of the elevators can be examined by switching to the Advanced mode and accepting the invitation to fill the tables based on Standard mode inputs. Assumptions are based on actual measurements. However, because of the number of different configurations that Elevate can model, values for each individual configuration have to be estimated. Elevate does not attempt to prevent impractical selections (e.g. it will not prevent you from analysing a high-speed hydraulic elevator). The results should be used for general guidance only. For improved results, use actual measurements and apply them in Advanced mode.